CC Debugger

The CC Debugger is primarily used for Flash programming and debugging software running on CCxxxx
8051-based System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these
purposes are the SmartRF™ Flash Programmer from Texas Instruments and IAR Embedded
Workbench® for 8051 from IAR Systems.

When connected to the debugger, the SoC devices can be controlled directly from SmartRF™ Studio.
SmartRF Studio is also able to control supported CCxxxx RF transceivers (CC2520, CC2500, CC110x,
CC11xL, CC112x, CC120x) when they are connected to the debugger.

How to solder small pins

If you're a maker like me who likes to test your ideas out with free samples (Texas Instruments, Microchip) then you'll want SMT & SMD soldering as a skill in your arsenal.

I'll be covering David Merrill's guide on soldering small pins, because I believe it's the best strategy with the resources many hobbyists have access too.


The tools I'm using in this demonstration are:

• BLE112 Bluetooth Smart Module
• BLE112 Bluetooth Low Energy Breakout
• SMT parts
• soldering iron
• solder
• flux

First thing you always need to do when soldering, is to find a open space where there is good airflow and sufficient lighting and of course a power supply for the soldering iron.  Basements are garages are usually good, and a fan can help if the area is on the smaller side.

Gather all your materials, and get settled in your workspace.

<workspace picture>

A great method for soldering small pins is to pre-solder all the pins on the SMDs and board.

<pre-soldered picture>

Once soldered, lay the parts down in their respective locations, and join the solder nodes together by gently touching the solder to the pins.

<soldered board>

It's as simple as that.  Now just interface your module and see if it gives you a good response!

I'm also going to write up a little guide for using conductive-glue pens, so stay tuned!